The Man in Black 3D Printed Miniature – Escape from Dulce

The Man in Black 3D Printed Miniature – Escape from Dulce does not shout. He does not posture. He simply stands — and the room bends around him.

Inside the depths of Dulce Base, power rarely looks dramatic. Instead, it wears a tailored suit and speaks in measured sentences. However, behind that calm exterior lies something far more dangerous. This sculpt captures that tension perfectly. The posture is upright, the coat lines are razor clean, and the stance is restrained. Consequently, the miniature radiates authority without visible aggression.

Unlike louder antagonists, this character’s threat is psychological. Therefore, the clean silhouette and minimal motion become deliberate design choices. At smaller scale, he reads as composed. At larger scale, he becomes imposing. Either way, the symmetry and vertical structure command attention on the tabletop.

Each model is resin printed in-house using high-resolution equipment so edges remain sharp and surface transitions stay crisp. Every piece arrives primed in Citadel Wraithbone White. As a result, painters can lean into stark noir palettes, muted shadow work, or subtle tonal layering to emphasize his quiet dominance.

Because each miniature is produced to order, please allow up to two weeks for manufacturing before shipment.

Available Sizes

• Standard: 38mm H × 25mm W × 26mm D (1.50″ H × 0.98″ W × 1.02″ D)

• 200% Scale: 76mm H × 50mm W × 50mm D (2.99″ H × 1.97″ W × 1.97″ D)

• 400% Scale: 153mm H × 101mm W × 101mm D (6.02″ H × 3.98″ W × 3.98″ D)

Features

• Central antagonist from Escape from Dulce

• Clean, controlled stance with commanding presence

• Sharp tailoring and subtle facial detailing

• Strong vertical silhouette for tabletop clarity

• Resin printed for crisp edge retention

• Primed and finished in-house