Kaltar the Atlantean 3D Printed Miniature – Escape from Dulce

Kaltar the Atlantean 3D Printed Miniature – Escape from Dulce balances royal ambition with seaside hustle. Once heir to a drowned throne, he now waits patiently above ground. However, patience does not mean surrender.

This sculpt captures that dual identity. The upright stance and trident establish authority, while the forward lean suggests readiness rather than nostalgia. Consequently, the miniature feels grounded and purposeful. The armor plates echo classical oceanic design, yet the posture reads practical and modern.

Unlike tragic fallen kings, Kaltar is not broken. Instead, he adapts. Therefore, painters can emphasize regal metallics, sea-worn patinas, or subtle corrosion effects along the armor edges. The trident provides a strong vertical focal point, whereas the layered torso armor invites controlled highlights and shadow transitions. At larger scales, the silhouette becomes stately; at standard scale, it remains crisp and tabletop-ready.

Each model is resin printed in-house using high-resolution equipment so fine detailing stays sharp and consistent. Every piece arrives primed in Citadel Wraithbone White. As a result, you can immediately build oceanic blues, oxidized bronzes, or bold contrast schemes.

Because each miniature is produced to order, please allow up to two weeks for manufacturing before shipment.

Available Sizes

• Standard: 46mm H × 25mm W × 25mm D (1.81″ H × 0.98″ W × 0.98″ D)

• 200% Scale: 91mm H × 50mm W × 50mm D (3.58″ H × 1.97″ W × 1.97″ D)

• 400% Scale: 183mm H × 101mm W × 101mm D (7.20″ H × 3.98″ W × 3.98″ D)

Features

• Atlantean ally from Escape from Dulce

• Regal stance with extended trident

• Armor sculpt with layered oceanic detail

• Strong vertical focal silhouette

• Resin printed for crisp edge definition

• Primed and finished in-house